1. Open the box with the Philips Screwdriver

2. Switch off the battery

Disconnect the wire marked C6 from the battery.

3. Unscrew the plug from the soil sensor

4. Remove the old sensor

Pull the soil temperature sensor cable towards you, starting with the plug, so that the soil temperature sensor comes through the black rubber cover last.

5. Insert the new sensor

Insert the new soil temperature sensor into the black rubber shield from inside the box. Push the tip through. Use the flat pliers to pull it all the way through and continue until there is 15-20 cm left in the box.

6. Connect the soil sensor cable to the socket.

7. Switch on the battery and close the box.

Connect the C6 cable to the battery and close the box with the Philips screwdriver.

8. Bury the soil temperature sensor

Use the Philips screwdriver to close the box and make a 10 cm deep hole in the ground where you can place the soil temperature sensor. Tie excess cable to the mounting rod with zip ties.

9. Turn on the station with the magnet.

Use the magnet to switch on the station by moving it in a circular pattern around the activation circle on the weather station.

You will receive data on your phone within approximately 10 minutes.

If the weather station is stuck in initialisation or cannot be turned on, repeat the previous steps without changing the battery, and wait at least 30 seconds from disconnecting power to reconnecting the battery.

‍